4.8 Differential Pressure Setting
This display allows the user to set the mode of DP detection. The GB6-B uses a Murphy
PD Gauge and should be left on this setting.
SECTION V: User Connections
The GB6-B has a row of connections set behind the controller front panel. See
Figure 3
below for further details on connecting the PD gauge and solenoids.
Figure 3 User Connection Terminals
5.1 PD
These are the terminals for the PD gauge. Polarity is not important. The gauge should be
mounted such that the blue fitting is closest to the ground to prevent shorting of the
contact points in the event of a water leak. You may cover the contact points with
silicone or any water sealant to prevent shorting.
*PD GAUGE
SENSOR
For more information:
WEB: FLTR.com.au PHONE: (+61) 1300 62 4020 EMAIL: [email protected] SKYPE: Purple.Engineering
Summary of Contents for Tekleen GB6-B
Page 1: ...co I c o co 9...
