Topper
*Your canopy topper has been folded for shipment in a way that makes it easy to set up. Please
read these directions before unfolding topper.
1
. Beginning at one gable end of the roof frame, unroll top along the ridge pole, letting the ends hang
down over either end.
2.
Unfold the top, stretching it out over the entire roof frame and aligning the corners with the corner
joints of the frame.
*Instructions for re-folding at the end of the show are found on page 9.
3.
With the top rolled out over the frame, decide whether the heat/wind vents will be at the front/back
of your canopy or to the sides. Lift the edge of the valance along your designated front edge and
attach the two Velcro straps around the frame pole to hold the top in place while the legs are being
attached. (The rest of the straps will be attached after the top is up on it's legs.)
5
Velcro strap points
Velcro strap
points
4. VENTS:
Heat/wind vents can be opened and closed from inside or outside the canopy. To access from
inside, separate the Velcro strip along the bottom edge and reach through to roll up and secure the vent
panel. If you are confident of the weather forecast, you can roll them most easily from the outside before
attaching the legs.
