4. Ensure that you have all the accessories and
tools needed for assembly and operation.
This also includes suitable personal protective
equipment.
Q
Accessories
To operate this product safely and correctly, the
following accessories, i. e. tools and attachments,
are necessary:
o
Suitable personal protective equipment
Accessories and tools are available through your
authorised dealer. When buying always consider
the technical requirements of this product (see
“Technical data”).
If you are not certain, ask a qualified specialist and
get advice from your trusted dealer.
NOTE
u
This instruction manual contains information
and suggestions for several attachments and
their uses. The attachments mentioned are not
necessarily included in the shipment, but are
meant to indicate additional possibilities for
using this product.
Q
Assembly
Attaching the lower bar
1. Fold up the lower bar
3
to a convenient
height and engage the gears in a secure
position (see. Fig. D). Raise both lower
bars
3
to the same height.
2. Turn the lever
10b
clockwise to tighten the
connection, but to not fully tighten it.
3. Tilt down the lever
10b
to secure the
connection. If this requires too much force or
is impossible loosen the lever
10b
a little by
turning it anti-clockwise.
4. Repeat step 1 – 3 on the other side.
Attaching the upper bar
1. Align the open end of the upper bar
2
with
the lower bars
3
and slide it down until the
holes in both parts are congruent with each
other and hold it in place (see Fig. E).
2. Fit the bolt
13a
from the product centre
outward through the holes and hold it in
place.
3. Slide the washer
13b
with the flat side facing
outwards onto the bolt
13a
. The recess of the
washer
13b
should fit the upper bar
2
.
4. Screw the lever
13c
onto the bolt
13a
.
5. Turn the lever
13c
clockwise to tighten the
connection, but to not fully tighten it.
6. Tilt down the lever
13c
to secure the
connection. If this requires too much force or
is impossible loosen the lever
13c
a little by
turning it anti-clockwise.
7. Repeat step 1 – 6 on the other side.
Securing the control cable
1. Use the cable clip
12
and insert the control
cable
14
through the open end (see Fig. F).
2. Clip the cable clip
12
with the control
cable
14
onto the lower bar
3
.
Q
Before use
Q
Charging the battery pack
NOTE
u
The battery pack
17
comes partly charged.
Charge the battery pack
17
prior to first use,
ideally at least 60 minutes.
u
Always pull out the power plug
18a
of the
charger
18
from the mains before removing
or connecting the battery pack
17
to the
charger.
u
Never charge the battery pack
17
when
the ambient temperature is below 10 °C or
above 40 °C.
u
Rest the charger
18
for at least 15 minutes
between successive charging sessions.
u
If no battery pack
17
is inserted into the
charger
18
and the charger is connected to
mains, the charging status LED
18d
flashes
green.
1. Align the battery pack
17
to the rails of the
charger
18
and slide it in. Ensure it clicks
noticeably in place.
14 GB
