34
GB MT
Assembling instructions
Do not insert the battery until
the appliance is fully assem-
bled. Risk of injury!
To put on the protective
cover:
1. Place the protective cover (14) on
the motor head (10) and screw it
down with the 3 Phillips screws
(14a).
Mounting the trimming unit:
2. Slip the cutting disc (12) onto the
axle. There is only one mounting
position. Screw the cutting disc
(12) to the axle. Take note: The
screw is a left-handed thread and
should be turned anti-clockwise to
tighten and clockwise to loosen.
Please ensure that the screws
(12a) are properly tightened.
Place the cutting insert (13) on the
pin (23) on the cutting disk (12) and
pull out the insert until it snaps in.
Spare cutting inserts are kept in
the box (
4) on the auxiliary
handle (
5).
To put on the auxiliary
handle:
3. Pull the ends of the auxiliary han-
dle (5) to extend the handle and
slide it over the handle holder
(22). The storage box for your pla
-
stic knife (4) must point upwards.
4. Screw down the screw (23) in the
auxiliary handle (5).
To insert the battery:
5. To insert the battery (16), place it
on the guide track (20) and push
it into the appliance. It will audi-
bly snap in.
Operation
Caution: risk of injury! Do not
operate the appliance with-
out the protective cover. To
operate the appliance, wear
suitable clothing, eye and ear
protection.
Prior to every use, check that
the appliance is operative. Do
not block the On/Off switch or
the switch lock. They must reli-
ably turn off the motor when
you release the switch. Do not
operate the appliance if one of
the switches is damaged.
Please observe local regulations
concerning noise protection.
Turning on and off
Maintain a firm stand and hold the
appliance well with both hands and at
some distance away from your body.
Before turning on the appliance, check
that it will not touch any objects.
1. Check that the battery (16) is in
(see “Assembly instructions - In-
serting the battery”).
2. To turn on, use your thumb to
actuate the switch lock (3), then
press the On/Off switch (2). Re
-
lease the switch lock.
3. To turn off, release the On/Off
switch (2). There is no continuous
operation mode.
