SATELLITE 480 MKII
Floorex Products
8.
1800 356 673
Tooling position & Magnetic plugs
01.
To remove tooling from the magnetic plugs, Tilt the machine to the tooling position as per instructions in the operating
instructions and grasp hold of the diamond disk and give it a sharp pull away from the main black disk.
02.
To remove the plug from the main black disk strike the black disk beside the taper insert as shown below.
03.
The magnetic plugs must be cleaned from dust and other debris every time the insert is removed. The insert should go in
all the way up into the plug up to the step in the insert. If not clean out the hole as described below.
04.
Ensure the insert is not worn more than 30% through where the blade runs on the insert
05.
Clean out the hole in the plug where the insert goes. Ensure there are no particles or pieces of steel (such as staples ETC).
06.
Refit the insert on the blade and put the two onto the plug ensuring the insert goes completely into the plug
07.
The Magnetic Plug hole where the insert goes can be cleaned with a screwdriver to remove packed dust etc.