floorex Beaver 250, Safety And Operators Manual & Parts Listing

Page: 10 / 19

Beaver 250
1800 356 673
9.
1800 - FLOOREX
Operating instructions
12. The beaver 250 has axle height adjustment to adjust the angle of attack.
Set the axle height at the lowest position before each job and move up
only if the machine repeatedly rises over the material being removed.
13. Connect machine to suitable power outlet. Only use a power lead suitable
for high current use (preferably 1.5 mm² cable), no longer than 20 meters.
14. If no power is available within the specified distance, have a qualified
person install a suitable power outlet closer to your work. Alternatively
use 2.5mm² cable for up to 50 meters.
15. Keep machine clear of drainage pits and grates or any such hazard.
Failure to comply could result in bodily injury and or could damage the
machine or property.
16. Ensure machine is on a level surface and handle is not folded (see
operation mode on the previous page).
17. Hold the handles firmly and switch the machine on by moving the switch
to the “ON” position.
18. If the over load trips it indicates a problem. (Undersize power lead or poor
power to GPO outlet). Refer above for recommendations on power leads.
Rectify the problem before continuing. Continuing to use the BEAVER 250
when constant tripping occurs, VOIDS THE WARRANTY!
19. This machine is designed to operate with the wheels in contact with the
floor at all times. Do not operate with wheels off the floor.
20. Do not attempt to make any adjustments while the machine is in
operation. Any adjustments must only be performed when machine is
stopped and power disconnected.