floorex Beaver 250, Safety And Operators Manual & Parts Listing, Page: 8 / 19

Beaver 250
1800 356 673
7.
1800 - FLOOREX
Operating instructions
1. Wear clothes suitable for the job and for the work place including, safety
shoes, hard hat, hearing protection, non-fogging vented safety goggles,
and dust respirator suitable for dust and dust mask suitable for dust and
Safety Gloves when changing Blades and accessories.
2. WARNING! POISONOUS EXHAUST GASES. Do not operate petrol
powered equipment without adequate ventilation. Carbon monoxide is an
invisible odorless gas that can harm or can kill you.
3. Be sure all equipment is tested and tagged prior to use on any job.
4. Inspect entire area in which the machine will operate and remove any
bolts or concrete nails etc. that could damage the tooling or machine and
which could cause a hazardous situation.
5. Ensure there are no obstacles or existing structures that could present a
hazard to the operator. If so, take necessary action to eliminate the
hazard.
6. Disconnect the power lead from the Beaver 250 before changing blades or
accessories. Failure to comply could result in bodily injury.
7. Fold handle to the operating mode (see operating mode on following
page) and lock in place using the locking levers, then tilt machine back so
handle is resting on the floor. (See “Blade Removal Mode” on the
following page)
8. The blade is removed by undoing the four M12 socket head cap screws
located underneath the blade clamp.
9. Install appropriate tooling into the machine. Only use genuine BEAVER
250 tooling. Failure to comply could result in bodily injury.
10. See “Tooling Uses and Applications” section for more detail on different
tooling and the application to use that tooling.
11. Tilt the machine back onto the blade.