Flo Vigaro, Instruction Manual

Page: 40 / 64

Cleaning / Disinfection / Processing
40
10.4 Processing / Reuse
The following steps must be carried out before passing on the system to a new
user:
-
Replace the beaker (Art. no. 31100010)
- Replace the particulate filter (Art. no. 40100111)
-
Replace the carrying handle (Art. no. 30100235)
-
Replace the humidifier lid (Art. no. 31300011)
-
Replace the connecting joint (Art. no. 30100245)
-
Replace the 90° connecting joint (Art. no. 51000040)
- Replace the carrying bag (Art. no. 4080001x)
- Disinfection using the Keredusy system (KR 1000)
See the service manual for detailed information.
10.5 Disinfection
You can disinfect the housing, mains cable, hose system and the humidifier if
required, e.g. after infectious diseases or in the case of exceptional soiling.
Refer to the instruction manual for which disinfectant to use. We recommend
wearing suitable gloves during disinfection, e.g. household rubber gloves or
disposable gloves. Before disinfecting the device, you should clean it as
described in the cleaning overview.
These recommendations do not apply if there is a change of patient!
The housing of the FLO Vigaro and its mains cable are cleaned by simply
wiping with disinfectant. You can use a hydrogen peroxide solution (3% / 5%)
for this.
Caution!
During disinfection, the device and mains cable must
be disconnected from the mains power supply!
You can also disinfect the humidifier using a hydrogen peroxide solution (3% /
5%). It is also possible to use thermal disinfection (boiling) to disinfect the
beaker.
To do this, place the beaker in a pot with sufficient warm water and heat it up
(put a dishcloth under the beaker if necessary) Boil the beaker for 5 minutes.
Let the pot and beaker cool off and then dry them.