•
Do not use this product for any purpose other than
that for which it was designed
•
Ensure desk/work surface is suitable to take the
weight of the arm/s and monitors
•
Supported weight must not exceed the maximum
load per arm
•
Ensure all screws are tightened and occasionally
adjust if needed
•
Ensure post is pushed fully down onto clamp before
installing the arm and monitor
•
Clean with a damp cloth, NO solvents
•
The use of power tools, lever bars or excessive force
during the installation, or re-configuration of the
product will invalidate your guarantee
•
Failure to observe the recommendations in the use,
and configuration of these products may affect your
guarantee
WARNING
MAINTENANCE and INSPECTION
DISCLAIMERS
DYN-013-AS09-INST-A MAY2012
Flo Split Desk Clamp
Setting 1
Setting 2
Setting 3/4
Setting 4: 71mm (2 3/4”)
Setting 2: 28mm (1”)
Setting 3: 40mm (1 1/2”)
Setting 1: 13mm (1/2”)
Maximum Desk Thicknesses
•
Take care when installing as fingers could become
trapped
Reconfiguring the 180
˚
stop function
The Flo clamp base is factory fitted with a
180
˚
stop feature. You can permit 360
˚
rotation
by simply pulling the cover and base from the
clamp and repositioning
the stop feature as shown.
180
˚
rotation configuration
180
˚
360
˚
rotation configuration
360
˚
Fully tighten the screw
Fit M6 screws
into clamp plate
(for desks with screens
follow step first)
1
4
4
Fit clamp to worksurface. Ensure
back of the clamp is flush against
edge of the worksurface
5
Tighten M10 clamp screw
2
3
Fit clamp plate
to bracket using
hole position to
suit required
desk thickness
Fit M10 screw to clamp plate
with clamp pad in position
DYN/013/AS09
