FLO-DYNAMICS TSD440, Operation Manual

Page: 14 / 25

14
Printed in the U.S.A. for Shift-Rite ®
Operations Manual
II. System Features & Specifications Flo-Dynamics
®
TSD440™
2.05 SPECIAL FUNCTIONS
DANGER
• Wear safety goggles an te clothing, user and bystander.
te
d pro ctive
etal tools on y ry.
id.
d fluid according to environm
and and follow Safety Instruct and on
roduct safety labels.
TOTALIZER CHECK
number indicates how
ount
the tanks. To empty
LL the fluid, select either Option 3 or 4 by repeatedly pressing the “OPTIONS” button. Press and
ank begins to drain. The pump will continue to run
med again before
r an audible
3. Reset this number to zero by pressing the “START” button.
uid reservoir, and record the number that shows
5. Scroll through the options menu until “OP 9” shows on the display, followed by a number.
move the used fluid
nt.
art of ATF fluid into the used flu
nsors
tolera ce.
e etween the values is st
a ts to or er a ne board
mpletely dra ed, th efore
another exchange is performed.
• Do not smoke, place m batter or allow a spark or flame in vicinity of bat
ps to them. • Clean battery terminals before hooking the machine’s battery cli
Avoid contact with automatic transmission or power steering flu •
• Dispose of use
ental laws and regulations.
• Read, underst ions in the front pages of this manual
p
•
Hold “STO ately 5 . P” button for approxim seconds
The control panel will first display a dash with up to a 3 digit number. This
many times the to
h t uarts/liters. After a short delay, the total am talizer as rolled over a 9999 q
of fluid used since last rollover will be displayed in quarts/liters.
• COMPLETELY DRAIN TANKS
y draining the tanks using Options 3 and 4, a small amount of fluid is left in B
A
hold the “START” button for 13 seconds, until t
until the “STOP” button is pressed.
NOTE: After tanks are completely drained, the system must be pri
nother exchange is performed. a
SENSOR CHECK •
This feature allows you to test the accuracy of the new and used fluid sensors.
1. Press and hold the “OPTIONS” button for at least 6 seconds, until you hea
beep.
2. Scroll through the options menu by repeatedly pressing the “OPTIONS” button, until “OP
8” shows on the display, followed by a number.
4. Pour 1 quart of ATF fluid into the new fl
up on the display.
6. Reset this number to zero by pressing the “START” button. Re
screen located in the bottom of the recessed hose tray compartme
7. Pour 1 qu id reservoir, and record the number that shows
up on the display.
8. If the difference between the new and used fluid sensor values is less than 3, the se
are within
n
9. If the difference between the new and used fluid sensor values is greater than 3, repeat
steps 1 - 8.
10. If the differenc b ill greater than 3, refer to Appendix C -
Replacement P r d w .
NOTE: After tanks are co in e system must be primed again b