10
3.4
Transmitter Connections
3.4.1.
Power supply
Please pay attention to the power supply. Please connect related power supply according
to the symbols of connecting terminals.
3.4.2.
Transmitter connections
Once the flowmeter is installed at the designated place as required, you can start connections.
Please connect the cable according to the wiring mark, the specific explanation is as follows:
DC+
Power supply DC10-
24
V
+
DC-
Power supply DC10-
24
V
-
IOUT+
4-20mA Output
IOUT-
A
RS485 Communication
(Modbus)
B
In2+
Temperature transducer positive outlet
In2-
Temperature transducer negative outlet
GND
Temperature transducer negative outlet
Warning!
Please ensure that the flowmeter is connected with the power off, and ensure that it has been
reliably grounded before use
.
3.4.3
Power on
When switching the power on for the first time, the flowmeter will run automatically
according to the parameters you put last time (the meter is calibrated before leaving factory).
After the flowmeter is installed and powered on, you can check its status in M04 menu; if it
displays “*R”, it indicates that the flowmeter is running normally.
If you use the flowmeter in a new environment, you need to input related parameters.
Any parameters you input would be kept in its memories forever till you correct them again.
If you need to adjust its installation position or the position of the transducer, you need to
input and set related parameters again of the flowmeter to ensure normal use.
DO always finish all tasks when running. No matter in any displays, tasks including
measurement and output should be finished as usual.
