Install Camera
CP-6408-21-I QIG
4
© 2019 FLIR, Inc
Page
3.4 Connect the Camera
Connectors
Connector
Connection
1
DC12V IN
If using a 12Vdc pow er supply, connect its w ires to the tw o-
pin pow er connector.
2
UPOE
Attach a Cat 5e or Cat 6 cable from the netw ork sw itch to the
RJ45 connector for a 10/100/1000 Mbps Ethernet and UPOE
connection. If using UPOE, FLIR recommends using a FLIR CP-
POE-60W-XX or equivalent pow er injector. Verify that the
UPOE connector LEDs are steady green and flashing yellow .
3
AC24V IN
If using a 24Vac pow er supply or a heater, connect its w ires
to the three-pin pow er connector.
4
DEFAULT
To reset factory defaults at any time, press the Default button
for at least 20 seconds.
5
14-pin
terminal
block
Attach w ires from external devices to the 14-pin terminal block
connector for alarm and audio in/out (see diagram and
definitions below ).
6
Analog
Out
Analog Out is not supported on this model
