Getting Started
CP-6408-21-I QIG
2
© 2019 FLIR, Inc
Page
1.Getting Started
1.1 Check Contents
1. CP-6408 4K IR PTZ
2. Pendant Cap
3. M4 Security Screw with Rubber Washer
4. 2-Pin Power Terminal Block (DC 12v use)
5. 3-Pin Power Terminal Block (AC 24V use)
6. 14-Pin Alarm/Audio I/O Terminal Block
7. Quick Install Guide (this document)
1.2 Download Documentation and Software
Use the QR Code on the front page or navigate directly to the FLIR Camera
Catalog, select the Quasar CP-6408 4K IR PTZ, and download the full support
documentation, Installation Guide and utility software (DNA).
Note: The minimum version of DNA required to support this camera is 2.3.0.8
2.Preparation
2.1 Load Host or Workstation Software
Install DNA
Download Documentation and Software
as shown, and install the DNA Utility to a
Host or Workstation that is on the network to which the camera will be connected.
2.2 General Preparation
CAUTION:
This product contains a battery that is soldered to the PCB. There is a risk of explosion
if the battery is replaced by an incorrect type.
Do not replace the battery.
The battery should be disposed of in accordance with manufacturer’s instructions.
2.2.1 Bench Setup (Optional)
If you wish to do preliminary setup before Installation, please consult the camera's
User Guide for setting IP Address and Video Format.
