FLIR mariner, Operator'S Manual

Page: 14 / 48

3 – Getting Started
8 11/06 427-0010-00-10, version 120
3.3 Installation
3.3.1 Camera Mounting
Mount the camera with the front of the base facing the intended viewing
direction. The camera base mounts with three #8 x 1
″
flat head screws
which are provided.
Step 1 Drill the screw mounting holes and 1.125
″
cable through hole per
the installation template provided in Chapter 7 “Mounting
Templates” on page 25. A sketch is shown in Figure 3-4.
Step 2 With the gasket under the base, feed the cables through the hole
and fasten the camera in place using the three #8 x 1
″
flat head
screws or three #8 x ¼
″
sheet metal screws.
Caution! The ThermoVision
®
Mariner is intended to be mounted with the
pedestal flat and sealed to a horizontal surface with the camera above
the mounting plane. Any other type of installation is not appropriate and
could result in undesirable operation and will void the warranty.
Figure 3-3: Mariner Outline