FLIR Lorex LH070 Series, Instruction Manual, Page: 57 / 144

Using the Main Menu 15
15.5 Alarm
The Alarm menu allows you to configure Motion Detection.
15.5.1 Configuring Motion Detection
Configure motion settings to determine the area you wish to monitor for motion events,
and the outcome if a motion event occurs.
To configure motion settings:
1. Select the Motion tab.
2. Configure the following:
• CH : Select the channel you wish to configure.
• Sensitivity : Select a motion sensitivity of Low , Medium , or High . Select Disable
to deactivate motion recording.
• Sensitivity : Select motion sensitivity. The greater the number, the greater the
sensitivity.
• Buzzer : Select the duration the system will "beep" when motion is detected. Or se-
lect OFF to disable the "beep" during motion events.
• Post Recording : Enter the post recording duration (the time the system continues
to record after a motion event occurs).
• Show Message : Select the checkbox if you want the system to display a system
message when motion is detected.
• Send Email : Select the checkbox if you want the system to send email notifications
if motion is detected. Email notifications must be configured.
• Full Screen : Select the Full Screen check box so that the system goes into full
screen mode when motion is detected.
• Record Channel : Select the channel you wish the DVR to record during motion
recording.
3. Click Apply to save your settings.
#LX400080; r.40436/40436; en-US
49