FLIR Lorex LH070 Series, Instruction Manual, Page: 137 / 144

Troubleshooting 23
Error Possible Causes Solutions
• There is no picture on moni-
tor/TV after connecting it to
the DVR. • Monitor/TV not detected by
DVR. • Power off the monitor/TV and
DVR. Power on the monitor/
TV, and then power on the
DVR.
• Input channel for DVR not se-
lected on monitor/TV. • On the monitor/TV, select the
input channel the DVR is con-
nected to.
• Video cable is loose or has
become disconnected. • Check the video cable con-
nection to the DVR and moni-
tor/TV.
• Video-out resolution has
been set to the incorrect
setting.
• Press and hold the but-
ton on the remote control un-
til the DVR restarts. The DVR
will reset to the default reso-
lution (1024x768).
• Mouse not detected by
system. • Mouse cable is not firmly
connected to the system.
Mouse is not connected to
the system. • Firmly connect the mouse ca-
ble to one of the USB ports.
• System needs to be reset • Power off the system (discon-
nect power cable). Firmly
connect a USB mouse to one
of the USB ports. Reconnect
the power cable to the DC
12V port on the rear panel.
• There is no picture on se-
lected channels / camera
picture is not being displayed. • Camera cables are loose or
have become disconnected. • Check the camera video ca-
ble and connections.
• Disconnect and reconnect
the cable at the system and
at the camera.
• Try moving the camera to an-
other channel or use another
cable.
• The image on the DVR ap-
pears, but does not have
sound. • The LH070 Series does not
support audio recording.
• The system beeps at startup. • The beep at startup is normal.
• The system beeps during
motion detection. • Motion detection is enabled
and the buzzer is activated. • Open the Main Menu and
click Alarm>Motion. In the
Buzzer drop-down, select
OFF. Click Apply.
• I am not receiving email
notifications. • Email notification is disabled. • Ensure you have configured
email notification. For details,
see 15.4.4
Setting up Email
Notification , page 46.
• Default setting is disabled,
but you have not entered your
own SMTP information. • If you want to use your own
SMTP server, deselect the
Default box, and enter your
SMTP Server address, Port,
User name, and Password in
the respective fields.
#LX400080; r.40436/40436; en-US
129