FLIR Lorex LH070 Series, Instruction Manual, Page: 55 / 144

Using the Main Menu 15
To set up email notification:
1. Click the Email tab in the Network menu.
2. From the Email drop-down menu, select from:
• Default : Uses the Lorex email server to send out notifications. This is the recom-
mended selection.
• Enable : Uses custom email server settings.
• Disable : Disables email notification.
If you want to use Lorex’s email server (recommended):
1. In the Email drop-down menu, select Default .
2. In the Sender Email field, enter the email address of the sender. This can be any
email address of your choice.
3. Under Reciever Email , click Setup and enter the email addresses you want the DVR
to send notifications to.
4. In the Interval drop-down menu, enter the duration the DVR must wait before sending
out a new notification.
For example, if you select a 3 minute interval, the DVR will send out email notifications
every 3 minutes until the DVR stops detecting motion. The DVR will only send out noti-
fications when it detects motion.
5. Click Apply to save your settings.
If you select "Enable", and want to use your own email server:
1. Configure the following:
• SSL : Select ON/OFF to enable/disable Secure Socket Layer protocol.
• SMTP Port : Enter the port used by your SMTP server.
• SMTP Server : Enter your SMTP Server address.
• Sender Email : Enter the sender email address. This can be any address of your
choice.
• Sender Password : Enter your email server’s password.
• Receiver Email : Enter the recipient’s email address.
• Interval : Enter the interval the DVR waits before sending a new email notification.
#LX400080; r.40436/40436; en-US
47