FLIR IP Series, Instruction Manual, Page: 49 / 144

Setup 5
4. Check Relay-out to trigger an alarm out device when Disconnection errors occur.
Under Alarm Delay , enter the number of seconds before the alarm out device will be
activated.
Note
Relay-out is only available if your camera supports alarm output. Check the technical specifications
for your camera.
5. Check Send Email to send an email alert when Disconnection errors occur.
6. Click Save to save changes.
5.4.8 IP Conflict
An IP Conflict error occurs if another device is assigned the same IP address as the IP
camera.
To configure IP Conflict errors:
1. Check Enable to enable IP Conflict errors.
2. Check Record to record to the microSD / SD card when IP Conflict errors occur.
Note
The camera must support microSD / SD card recording to use this function. Check the technical
specifications for your camera.
3. Under Record Delay , enter the number of seconds the camera will record after an IP
Conflict
4. Check Relay-out to trigger an alarm out device when IP Conflict errors occur. Under
Alarm Delay , enter the number of seconds before the alarm out device will be
activated.
Note
Relay-out is only available if your camera supports alarm output. Check the technical specifications
for your camera.
5. Check Send Email to send an email alert when IP Conflict errors occur.
6. Click Save to save changes.
5.4.9 Network
Some cameras group the IP Conflict and Disconnection warnings into a single Network
warning tab.
#LX400038; r. 1.0/18537/18537; en-US
41