FLIR IP Series, Instruction Manual, Page: 39 / 144

Setup 5
6. Repeat steps 4 & 5 for as many preset locations as you would like in the tour. When fin-
ished, press Save to save the tour.
You can press the Start button to test the tour, then Stop to stop the test.
To delete a tour:
• Click next to the tour you want to delete to remove it from the list.
5.3.3 Scan
An auto scan automatically cycles between a set left and right limit.
To add a scan cycle:
1. Under PTZ > Function , click Scan .
2. Under Scan No. , select the scan cycle you would like to configure.
3. Click Set .
4. Using the PTZ controls, move the camera to the leftmost point of the scan pattern you
want to set and click Left Limit .
5. Move the camera to the rightmost point of the scan pattern you want to set and click
Right Limit .
6. Under Speed , click - / + or use the slider to set the speed of the scan cycle. Setting a
higher number means the camera will move faster between the left and right limits.
7. Press the Start button to test the scan cycle, then Stop to stop the test.
5.3.4 Pattern
You can use the pattern function to record a series of camera movements to recall later.
To save a pattern:
1. Under PTZ > Function , click Pattern .
2. Under Pattern No. , select the pattern cycle you would like to configure.
3. Click Set .
#LX400038; r. 1.0/18537/18537; en-US
31