427-0101-01-12 Revision 100
September 2020
36
This document does not contain any export-controlled information.
Configuration
Name
Enter a unique, friendly name for the radar, using only alphanumeric characters. The default name
for the radar is the model (R-290) followed by its serial number.
To upgrade the radar’s firmware:
Step 1
Make sure the radar has been recently rebooted.
Step 2
Under Upgrade version, click
Find file
.
Step 3
On your computer or network, browse to and select the firmware file.
Caution!
Step 4
Click
Upgrade
.
The radar uploads and installs the firmware, which takes a minute or two. After installing firmware,
the radar requires a reboot. When prompted, confirm rebooting the radar.
Factory Defaults
Click
Full Reset
to return the radar its original factory configuration.
Click
Partial Reset
to maintain network and IP settings while returning all other settings to the
factory configuration.
Click
Reboot
to cause the radar to power cycle and reinstall configuration files.
Tip
Support System Info
Set the logging details up to four log levels; higher log increase the size of the log file.
Click
Download
to retrieve the radar’s log files.
Only upgrade to firmware developed for the Elara Radar.
You can also return the radar to its original factory configuration by pressing the radar’s physical
hardware reset button for at least 20 seconds; for example, if you are unable to access the radar
via its web page or other communication method. The hardware reset button is located on the radar
assembly’s back panel (see
Enter radar name
Radar name