CM-3202-11-I QIG Rev 100
June 2020
This document does not contain any export-controlled information.
Internal interface
Description
6
RS232 terminal block
Not used
3.3 Route Cables and Connect the Camera
System Cable
Connector
Black
RJ-45
Pink
AUDIO OUT
Light green
AUDIO GND
Light blue
MIC IN-
Yellow black
MIC IN+
Purple
ALARM COM
Blue
ALARM OUT
Gray
ALARM IN
White
ALARM GND
Black
12 VDC-
Red
12 VDC+
a. Properly install the power and network cabling in the mounting hardware so that
it is accessible when the camera is mounted.
b. Attach an Ethernet cable from the network switch to the RJ45 connector for a
100 Mbps Ethernet and PoE (Power over Ethernet) IEEE 802.3af Class 3
connection. Ethernet is required for streaming video and for configuring the
camera.
c. Connect the audio, microphone, and alarm connectors, as needed.
d. If using a 12 VDC power supply, connect its wires to the two-pin power terminal
block.
Cables can enter the
camera from the side or
from the bottom.
Side cable entry
Bottom cable entry
3.4 Mount the Camera
a. Be sure to have the required accessories and tools available.
b. Refer to the camera's installation and user guide as necessary.
c. Paste the included drill template onto the wall or ceiling where you are mounting
the camera.
