Flipper Instructions
A22v2.NA & EU
(North America & EU)
7
Learning Set Up:
Flipper can “learn” (copy) the IR signals from your existing remote control. Each button is
programmed separately. When learning TV signals, use the
TV
button; when learning
STB functions, use the
STB
button.
It is helpful to do this procedure in low light, away from the TV or a light bulb. Light can
interfere with the IR signal. Flipper’s Learning IR bulb is the right side bulb.
1.
Place both Flipper and your device remote on a table with the tops facing one another.
2.
On Flipper, press and hold
TV
and
On/OFF
at the same time until the light starts to
flash. Release the buttons.
3.
Press and release the key on Flipper that you want to copy, for example, Volume Up.
The light will turn solid.
4.
Press and hold same key from your existing device remote until the light on Flipper
starts flashing. Once blinking, the learning process for that key is done.
5.
Keep repeating step 1-4 until you learn all the keys you want.
6.
Press
TV
to exit.
7.
Check the buttons to see if they learned to correct signal. If not, repeat the process as
needed until all buttons learn the desired function. It may take a few tries to learn all
signals.
Troubleshooting
Make sure Flipper is unlocked: press and hold
ADD
until the light turns solid, then enter
956. The light will blink out if locked. Also check TV and STB, as Flipper can be locked
in any mode. Sometimes lock Flipper, then unlock.
Code Retrieval
This feature lets you retrieve the code if using code search.
1.
Press
TV
(or STB) and then 1, and release both. Count the flashes – this is the first
digit.
Note
: If the light does not flash, the digit is zero.
2.
Press
TV
and then 2, and release both. Count the flashes - this is the second digit;
3.
Press
TV
and then 3, and release both. Count the flashes - this is the third digit.
Reset to factory settings
Make sure Flipper is unlocked. Press and hold the
ADD
button until the light turns solid,
then enter 954. The light will flash out.
