PNP Assembly Instructions
1.As the photo show, install the main wing
middle part on the middle of fuselage.
While placing, arrange and straighten all the cables, put
them into the space shown by the arrow, make sure that
no cables are pressed by the main wing, and then
use screws to fix.
Install the main wing middle part
Screw : PA 3×12mm 4pcs
Screw : PA 3×12mm 10pcs
2.As shown in the figure: Connect the servo cable
and extension cable, and then fix the left fuselage
to the middle main wing with screws.
Repeat the above steps to install the right wing.
Install two sides of the fuselage
Install the horizontal stabilizer
Screw : PA 3×12mm 4pcs
3
Item No.:FLW305
Version No.: FLW305-01
FlightLine OV-10 Bronco
3. As shown in the figure, when installing the horizontal
stabilizer, connect the elevator servo wire and the extension
line inside the vertical tail.
Make sure that the plastic parts at the two ends of the
horizontal stabilizer are fully inserted into the limit holes
between the inner sides of the two vertical tails.
Finally, fix it with screws
Note:
Connect the ESC wire and ESC
extension wire, need to follow the rules of
red-red, black-black. Incorrect connection may
cause the motor to reverse or the electronic
device to burn out.
Summary of Contents for OV-10 Bronco
Page 13: ......
