02.04.2022 | V1.02
-8-
Installation / Operation Manual
anemoi
4.
Mechanical Installation
Upon delivery, undertake visual inspection of the package contents for signs of transport damage and
verify the information on the type plate sticker against your order. Do not open the device housing.
For longer storage of the device, select a dry and clean environment. Make sure that the device is not
stored near strong heat sources and that no metal chippings or other dirt can get into the device or its
connectors.
4.1
Display Unit
The display unit is mounted either in front of the instrument panel or behind the instrument panel.
Second variant needs a rectangular cutout (dimensions in Table 3-1). Two mounting examples are
shown in Figure 4-1 and Figure 4-2.
Figure 4-1: Front side mounting
Figure 4-2: Rear side mounting
4.2
Sensor Unit
The sensor unit can be mounted behind the instrument panel or in the fuselage. By default, the
anemoi
is delivered with a 0.5 m (3.0 ft) wiring harness kit. As an accessory, a 3.0 m (10 ft) wiring harness kit is
available. The sensor unit is mounted with 4x M4 screws. The screw hole positions can be taken from
Figure 4-9.
The mounting position of the sensor unit is shown in Figure 4-3.
