7
Clave 23+ Instruction Manual v1.4
4. Installation
* Ensure that the sterilizer is installed with 10cm (4”) ventilation space on all sides of the
sterilizer and 20cm (8”) on the top. The clearance required to open the door is 40cm (16”).
* The sterilizer should be placed on a level work table.
* Do not cover or block the door or any ventilation areas on the sterilizer.
* Do not install the sterilizer near a sink or in a location where it is likely to be splashed with
water.
* Do not install the sterilizer near a heat source.
5. Operation
5.1 Setup
5.1.1 Open the door and remove all of the inner contents.
5.1.2 Connect the power cord to an outlet of the appropriate voltage.
5.1.3 Power on. The switch is located on the right side of the cover. After turning on the
machine, the LCD screen will turn on and show the door position, water level, working
program, date, time, etc.
Distilled water tank requires water.
Used water tank is full.
Printer is disconnected if it is blinking.
Door locked.
Notice:
Before using the sterilizer or when the low water level icon
blinks, fill the
distilled water tank with distilled water.
The LCD screen will go into sleep mode if a button has not been touched for some time.
You can exit the sleep mode on the screen by touching any button.
