12
7 Filter and dust bags - CVR 2000 / CVR 3000 / CVR 4000
of the cleaner till you hear a click. Push down the handles and
ensure that the vacuum unit and dust container are fitted
together properly.
7.3 Replacing the dust bag
The machine is supplied with a dust bag. Replace the dust
bag in the following way:
1. Release the two handles clamped on to the dust
container. The handles are easily unlocked by lifting up
the handles until they come to a stop. When you pull the
handles outwards away from the cleaner, the container is
released. Fig. 20.
2. Lift off the container.
3. Shake the dust from the bag filter. It may be
advantageous for the filter to be installed in the container
in such a way that dust in the filter can be shaken down
into the dust container.
4. Lift out the bag filter.
5. Remove the dust bag by taking hold of the cardboard
stiffener and carefully pulling out the card and bag from
the container, Fig. 22. Fold down the perforated part of
the cardboard towards the opening of the bag in order to
prevent the bag contents to leak out.
6. Empty the container of dust.
7.4 Fitting the dust bag
Replace the dust bag as follows:
1. Fit the dust bag’s card with a hole into the bag holder,
Fig. 23.
Fig. 21
Fig. 20
Fig. 23
Fig. 22
7.1 Replacing the filter
A bag filter must always be installed in the dust container.
Clean the filter in the following way:
1. Release the two handles clamping the dust container. The
handles are easily unlocked by lifting up the handles until
they come to a stop. When you pull the handles outwards
away from the cleaner, the container is released. Fig. 20.
2. Do not remove the filter from the container. Instead, give
the filter a light shaking inside the container to loosen dust
from the filter allowing it to fall into the container. This is
done by grasping the strap on the filter and quickly move
the filter up and down as shown in Fig. 21.
3. Lift out the bag filter. If a dust bag is being used - remove
the dust bag. Then empty the container of any remaining
dust in a suitable place.
7.2 Fitting the bag filter
Replace the bag filter in the machine as follows:
1. Replace the cleaned/shaken bag filter in the container.
Make sure the filter support fits into the inner edge of
the dust container properly. Check that the filter is fitted
the right way up - the cloth handle on the filter should be
visible.
2. Then replace the dust container with the bag filter in the
suction unit.
3. Attach the container on the suction unit by lifting the container
back in place and pushing the handles back in over the edge
