8
9
10
Step 4
04
Step 3
Step 5
Step 6
Take installation 1 as example, connect the cables to the control box (8)
Notice: Choose the location that will best suit your needs.
Power port
Port for cable
connected to
the leg
Port for
handset
E
4x4
A
x8
Installation 1:
Right-hand corner desk installation
Installation 2:
Left-hand corner desk installation
E
3
1
2
1
A
3
2
E
A
Floor
Floor
Long end
Attach the short foot (1) and long foot (2) to the
legs (3) using screws (A). Tighten with the
4x4 hex key (E).
Long end
E
4x4
1
B
x2
B
9
2
D
B
5
B
x14
Attach the handset (9) to
the back of the desktop.
Paste the square washers
in the square tube.
Adjust the tightness of 8
screws on the back of
supporting beam (5) by
using 4x4 hex key (E), make
sure the supporting beam can
move freely to fit the actual
size of your table.
Tighten screws up after adjusting
Attach control box (8)
to the desktop.
B
1
1
2
3
Tighten screws up
Slide the plate
4
2
B
x2
Notice: ways to install control box,
you can put control box (8) on the
cable management plate (4), shown
as step 5 and step 6-2; or you can
attach it to the desktop, shown as
step 6-1.
Take installation 1 as example, assemble cable management plates.
Take installation 1 as example, assemble the desktop.
03