Operators and Reference Manual
MC12
MC12 OM RM EN 74-111-132 v1.03.doc
Ver. 1.03
Page 34 of 47
6.7.42. Function 59 - Change access level
By entering function 59, the command line will prompt for a password.
Key in the 4 digits password from Function 58 for the desired access level for the operator
and press ENT.
Password protecting the MC12 is realised by establishing 3 Levels of operability from the
keyboard. The idea is to limit the number of functions and key's available to the operator. In
praxis the operator will have no response from the MC12, when trying to use functionality
that have been excluded in the current level.
When the MC12 is in Level 2 or 3 and parameters are to be changed or another programme
to be loaded, the supervisor must use Function 59 and key in the password for Level 1. Then
make the changes and use Function 59 again to put the MC12 back in Level 2 or 3.
6.7.43. Function 60 - Ext. Input Mode
Mode 1 or 2.
This function is activated when using foot switch in order to start/stop filling.
1- Foot-switch used only as start (Standard setting on FMB)
2- First push starts
Second push stops
Third push starts
Etc.
6.7.44. Function 70 – Cap. format
Capacity format: The number of fills carried out by the system can be measured per hour or
per minute.
1 = Fills per minute
2 = Fills per hour
Enter the required output format followed by <ENT> and it will be displayed in Function 10.
Function 70 is not shown in the status lines of the display.
