Operators and Reference Manual
MC12
MC12 OM RM EN 74-111-132 v1.03.doc
Ver. 1.03
Page 21 of 47
6.7.22. Function 25 - Delete Log
This function deletes all data stored in the log. It is recommended that the log is deleted
immediately after the log has been printed via Function 24.
When the function is called, the system will ask if the log is to be deleted.
If <Y> for 'yes' is pressed, all data in the log will be deleted.
If <N> for 'no' is pressed, the system will exit the function without deleting the data in
memory.
6.7.23. Function 26 - Log Status
This function displays the number of used and free bytes in the log memory.
5,000 bytes are reserved in the memory for logging data and Function 26 enables the user to
see how much capacity is left in this memory.
As the log is being progressively filled, the figure under FREE will become lower and the
figure under USED will become higher.
If the log (memory) is full and data is still being logged, these last data will be lost.
6.7.24. Function 29 - Print parameters
This function prints the current parameters via the connected printer.
The print-out is for the current drive or all the current drives.
When the function is called, the system will ask: “PRINT ACTUAL DRIVE (Y/N):
For print-out of the current drive only, press <Y>.
For print-out of all connected drives, press <N>.
The printing can now be started by pressing <Y>, or the function can be left by pressing <N>.
In both parallel and serial mode, the system prints out all parameters for drive 0. When
operating in serial mode the size of tube for all drives is printed.
If parameters for all drives are printed, the last part of the print-out will be repeated for all
connected drives, but with the respective parameters.
