www.flexco.com
—10—
Electric Belt Cutter
Tool Maintenance–Blade Replacement
(corded model shown)
If the Belt Cutter is difficult to operate, the blade may be worn and need replacement. Unplug drill from power source.
Always wear cut-proof safety gloves and safety glasses when replacing blade.
1. Loosen Rear Carriage Bolt.
2. Remove Carriage Support Bolt and Nut.
WARNING: DO NOT TOUCH BLADE.
3. Rotate Carriage away from Blade.
4. Remove Blade Mount Bolt.
5. Remove Blade Mount Shaft.
WARNING: Blade edge is very sharp.
DO NOT TOUCH EDGE OF BLADE!
Push the Blade Guard into the Cutter Housing just
enough to clear the Blade. Remove the Blade and
Blade Spacer carefully.
6. Carefully replace Blade Spacer and slide new
Blade into Housing. Align keyway in Blade, Spacer,
and Gearbox and insert Blade Mount Shaft.
Secure Blade with Blade Mount Bolt.
7. Carefully pivot Carriage back into place. Be
careful to not damage Blade as it slides between
the Belt Support Bearings.
8. Replace Carriage Support Bolt. Tighten rear
Carriage Bolt.
