background image

Academy of Model Aeronautics National Model Aircraft Safety Code

Effective January 1, 2014

A.  

GENERAL:

 A model aircraft is a non-human-carrying aircraft capable 

of sustained flight in the atmosphere. It may not exceed limitations of this 

code and is intended exclusively for sport, recreation, education and/or 

competition. All model flights must be conducted in accordance with this 

safety code and any additional rules specific to the flying site.

  1.   Model aircraft will not be flown:

   

(a)   In a careless or reckless manner.

   

(b)   At a location where model aircraft activities are prohibited.

  2.   Model aircraft pilots will:

   

(a)   Yield the right of way to all human-carrying aircraft.

   

(b)   See and avoid all aircraft and a spotter must be used when  

 

   

    appropriate. (AMA Document #540-D.)

   

(c)   Not fly higher than approximately 400 feet above ground level  

   

    within three (3) miles of an airport without notifying the airport  

       operator.

   

(d)   Not interfere with operations and traffic patterns at any airport,  

   

    heliport or seaplane base except where there is a mixed use    

       agreement.

   

(e)   Not exceed a takeoff weight, including fuel, of 55 pounds unless  

   

    in compliance with the AMA Large Model Airplane program.    

   

    (AMA Document 520-A.)

   

(f)   Ensure the aircraft is identified with the name and address or    

   

    AMA number of the owner on the inside or affixed to the outside  

   

    of the model aircraft. (This does not apply to model aircraft    

   

    flown indoors.)

   

(g)   Not operate aircraft with metal-blade propellers or with gaseous  

   

    boosts except for helicopters operated under the provisions of  

   

    AMA Document #555.

   

(h)   Not operate model aircraft while under the influence of alcohol  

   

    or while using any drug that could adversely affect the pilot’s    

   

    ability to safely control the model.

   

(i)    Not operate model aircraft carrying pyrotechnic devices that    

   

    explode or burn, or any device  which propels a projectile or    

   

    drops any object that creates hazard to persons or property.

  Exceptions:

  

§

  Free Flight fuses or devices that burn producing smoke and are    

   

  securely attached to the model aircraft during flight.

  

§

   Rocket motors (using solid propellant) up to a G-series size may be  

   

  used provided they remain attached to the model during flight.   

   

  Model rockets may be flown in accordance with the National  

 

   

  Model Rocketry Safety Code but may not be launched from model  

     aircraft.

  

§

   Officially designated AMA Air Show Teams (AST) are authorized to  

   

  use devices and practices as defined within the Team AMA  

 

   

  Program Document. (AMA Document #718.)

   

(j)   Not operate a turbine-powered aircraft, unless in compliance    

   

    with the AMA turbine regulations. (AMA Document #510-A.)

  3.   Model aircraft will not be flown in AMA sanctioned events, air shows  

   

or model demonstrations unless:

   

(a)   The aircraft, control system and pilot skills have successfully    

   

    demonstrated all maneuvers intended or anticipated prior to the  

   

    specific event.

   

(b)   An inexperienced pilot is assisted by an experienced pilot.

  4.   When and where required by rule, helmets must be properly worn   

   

and fastened. They must be OSHA, DOT, ANSI, SNELL or NOCSAE    

   

approved or comply with comparable standards.

B. RADIO CONTROL (RC)

  1.   All pilots shall avoid flying directly over unprotected people, vessels,  

   

vehicles or structures and shall avoid endangerment of life and  

 

   

property of others.

  2.   A successful radio equipment ground-range check in accordance    

   

with manufacturer’s recommendations will be completed before the  

   

first flight of a new or repaired model aircraft.

  3.   At all flying sites a safety line(s) must be established in front of which  

   

all flying takes place. (AMA Document #706.)

   

(a)   Only personnel associated with flying the model aircraft are    

   

    allowed at or in front of the safety line.

   

(b)   At air shows or demonstrations, a straight safety line must be    

       established.

    (c)  An area away from the safety line must be maintained for    

       spectators.

    (d)  Intentional flying behind the safety line is prohibited.

  4.  RC model aircraft must use the radio-control frequencies currently  

    allowed by the Federal Communications Commission (FCC). Only  

    individuals properly licensed by the FCC are authorized to operate  

    equipment on Amateur Band frequencies.

  5.  RC model aircraft will not knowingly operate within three (3) miles of  

    any pre-existing flying site without a frequency-management    

    agreement. (AMA Documents #922 and #923.)

  6.  With the exception of events flown under official AMA Competition  

    Regulations, excluding takeoff and landing, no powered model may be  

    flown outdoors closer than 25 feet to any individual, except for the  

    pilot and the pilot's helper(s) located at the flightline.

  7.  Under no circumstances may a pilot or other person touch an outdoor  

    model aircraft in flight while it is still under power, except to divert it  

    from striking an individual.

  8.  RC night flying requires a lighting system providing the pilot with a  

    clear view of the model’s attitude  and orientation at all times. Hand-

    held illumination systems are inadequate for night flying operations.

  9.  The pilot of an RC model aircraft shall:

    (a)  Maintain control during the entire flight, maintaining visual contact  

        without enhancement other than by corrective lenses prescribed  

        for the pilot.

    (b)  Fly using the assistance of a camera or First-Person View (FPV) only  

        in accordance with the procedures outlined in AMA Document  

       #550.

    (c)  Fly using the assistance of autopilot or stabilization system only in  

        accordance with the procedures outlined in AMA Document #560.

C. FREE FLIGHT

  1.  Must be at least 100 feet downwind of spectators and automobile  

    parking when the model aircraft is launched.

  2.  Launch area must be clear of all individuals except mechanics, officials,  

    and other fliers.

  3.  An effective device will be used to extinguish any fuse on the model  

    aircraft after the fuse has  completed its function.

D. CONTROL LINE

  1.  The complete control system (including the safety thong where   

    applicable) must have an inspection and pull test prior to flying.

  2.  The pull test will be in accordance with the current Competition   

    Regulations for the applicable model aircraft category.

  3.  Model aircraft not fitting a specific category shall use those pull-test  

    requirements as indicated for Control Line Precision Aerobatics.

  4.  The flying area must be clear of all utility wires or poles and a model  

    aircraft will not be flown closer than 50 feet to any above-ground  

    electric utility lines.

  5.  The flying area must be clear of all nonessential participants and  

    spectators before the engine is started.

If you are not an AMA member, please consider joining. Founded 

in 1936 and open to anyone interested in model aviation, the AMA 

is the governing body for model aviation in the United States and 

sanctions over 2,000 competitions annually. Membership in the 

AMA provides liability insurance coverage, protects modelers’ 

rights and interests, and is required to fly at most of the 2,700+ R/C 

sites nationwide.

Academy of Model Aeronautics

5161 East Memorial Drive

Muncie, IN 47302-9252

Toll Free (800) 435-9262

Fax (765) 741-0057

www.modelaircraft.org

18

Summary of Contents for QQ Extra 300





















Reviews: