Flex DD 4G 18,0-EC/5,0, Original Operating Instructions

Page: 26 / 336

DD 4G 18.0-EC
26
Charging process
CAUTION!
Insert only original batteries in the supplied
charger.

Insert the charger mains plug. The display
backlighting lights up green for 2 seconds
and then goes out again. OK is displayed.

Insert the battery fully into the charger
until it clicks into place.
– The time remaining in the charging
process (until the battery is fully
charged) and a graphic representation
of the state of charge are shown
alternately in the display.
– The display backlighting lights up
orange when the battery is charged
less than 80%.
– When the battery charge reaches 80%
the display lights up green and OK is
indicated.

The battery is fully charged when the
display appears.
The green backlighting goes out after
a short time.

Remove the battery from the charger.

Pull out the mains plug.
NOTE
If the display flashes after the battery is
inserted in the charger, there is a fault in the
battery or in the charger.
Display flashes slowly.
Backlighting orange.
The battery is too hot or too cold. The charging
process starts when the battery reaches the
charging temperature (0°C...55°C).
Display flashes rapidly.
Backlighting red.
Remove the battery from the charger and
insert again. If the same display persists, the
battery is faulty. Replace the battery or have
it checked at an authorised repair shop.
If this error message is displayed again with
a different battery, this indicates that there
is a fault in the charger. Have the charger
checked at an authorised repair shop.
Maintenance and care
Cleaning
WARNING!
If metals are worked over a prolonged
period, electroconductive dust may become
deposited inside the housing.

Clean the power tool and ventilation slots
at regular intervals. Frequency of
cleaning is dependent on the material
machined and the duration of use.

Regularly blow out the housing interior
and motor with dry compressed air. Keep
the power tool running while doing this.
Charger
WARNING!
Before performing any work, pull out
the mains plug. Do not use water or liquid
detergents.

Remove dirt and dust from the housing
with a brush or a dry cloth.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
476.552_DD_4G 18.0-EC.book Seite 26 Montag, 16. Juli 2018 12:26 12