Flex DD 4G 18,0-EC/5,0, Original Operating Instructions

Page: 24 / 336

DD 4G 18.0-EC
24
Torque preselection
CAUTION!
Change the torque only when the power tool
is stopped.

Move the torque setting turning dial to the
required position.
1–11: Screwing
: Drilling
NOTE
The safety clutch is deactivated in the
Drilling setting .
Speed preselection
CAUTION!
Change the speed only when the power tool
is stopped.
It is only possible to select the speed in the
direction indicated by the arrows!

Move the selector switch to the required
stage:
1: Low speed, high torque
4: High speed, low torque
Switching on the power tool
To switch the power tool on:

Press the trigger switch.
The power tool trigger switch allows the
operator to increase the speed in
increments up to the maximum speed.
To switch the power tool off:

Release the trigger switch.
NOTE
–
The power tool is equipped with a brake
which stops the cutting accessory as
soon as the trigger switch is released.
– When using the power tool continuously,
the operator should work primarily with
the trigger switch fully depressed.
Workplace lamp on/off switch
1. Turn direction of rotation preselector
switch (2) to “Forwards” or “Reverse”.
2. Press electric tool on/off switch (5)
– Workplace lamp lights up
3. Release electric tool on/off switch (5)
– Workplace lamp goes out
automatically after approx. 10 sec.
476.552_DD_4G 18.0-EC.book Seite 24 Montag, 16. Juli 2018 12:26 12