Flex CSM 4060, Operating Instructions Manual

Page: 20 / 76

Portable circular saw for metals CSM 4060
20

Insert the saw blade in the correct position.
Attach the front clamping flange (20 b) with
the flange on the outside and manually
tighten the locking screw (20 a) in
a clockwise direction.

Press and hold down the spindle lock (9).
Tighten the locking screw (20 a) in
a clockwise direction with an Allen key.

Attach the sawdust guard (15) and secure
with the Allen screws (7).
Switch on and off
Note
For reasons of safety the safety switch (4)
is not locked and must be held down during
sawing.
Switching on:

Press and hold down the starting
lockout (3).

Press and hold down the safety switch (4).

Release the starting lockout (3).
Switching off:

Release the safety switch (4).
Setting the cutting depth
Note
For optimum cutting results the saw blade
may project out of the workpiece by max.
3 mm.

Pull out the mains plug.

Loosen the clamping lever (10).

Set the required cutting depth:
Lift the saw off the base plate (11) = lower
cutting depth.

Tighten the clamping lever (10).