Flex CS 62 18.0-EC, Original Operating Instructions, Page: 23 / 316

CS 62 18.0-EC
23

Attach wing screw/clamping bracket/
spring for mounting the parallel stop (1.).

Insert parallel stop and set to required
width (2.).

Tighten the wing screw (3.).
Working with the power tool
CAUTION!
After the power tool has been switched off,
the saw blade continues running briefly.
When the rotating saw blade touches
the workpiece, the power tool may recoil.
NOTE
Excessive feed reduces the performance
of the power tool, impairs the cutting quality
and reduces the service life of the saw
blade.
Sawing along a scribe mark

Connect extraction hose.

Set cutting depth to the required dimension.

If required, set mitre angle.

Switch on dust extraction system.

Hold the handle with your right hand.

Place saw bench on the workpiece.

Switch on saw and wait until the saw
blade has reached the maximum speed.

Slowly feed the saw along the material.
NOTE
The cut marks on the saw bench show the
position of the saw blade for a right-angle cut.

Feed the saw evenly through the material.

After cutting:
– Switch off the saw. Saw blade continues
running briefly!
– When the saw is lifted, the saw blade
returns to the initial position and the
guard is locked.

At the end of work:
Thoroughly clean the electric power tool
and accessories.
Filter: