Flex CHE 2-26 18.0-EC, Original Operating Instructions

Page: 19 / 264

CHE 2-26 18.0
-
EC
19

Clean tools and lightly grease the shank.

Insert the cutting accessory (1.) and
turn (2.) until it locks.

Check lock by pulling on the cutting
accessory.
Removing the accessories
WARNING!
Remove the battery before carrying out any
work on the power tool.
CAUTION!
Used cutting accessories may become hot.
Wear protective gloves!

Pull the locking sleeve backwards (1.).

Remove the cutting accessory (2.).
Mounting keyless chuck
NOTE!
To fit a keyless chuck, the original adapter
from the FLEX accessories range is required.

Pull back the locking sleeve on the
keyless chuck (1.) and fit it on the spindle
until it is heard to engage (2.).

Check the lock by pulling on the keyless
chuck.
CAUTION!
Never use chiselling mode or hammer drill
mode when the keyless chuck is fitted!
The tool and keyless chuck could become
damaged.
Direction preselection
CAUTION!
Change the direction of rotation only when
the power tool is stopped.

Move the direction preselector switch to
the required position:
– Left: counterclockwise (remove screws,
release screws)
– Right: clockwise (drill, insert screws,
tighten down screws)
– Middle: switch-on interlock
(tool change, when working on the
power tool)