CHE 18.0
-
EC
17
Swivel the auxiliary handle into the
desired position (2.).
Secure the adjustment by turning the
auxiliary handle clockwise.
Attaching the depth stop
WARNING!
Remove the battery before carrying out any
work on the power tool.
Press and hold clamping lever on
auxiliary handle in upper area (1.).
Push in the depth stop (2.).
Set depth stop to the required drilling
depth.
Release clamping lever.
NOTE!
Push tool with SDS-plus shank in the
SDS-plus tool holder as far as the back
position. The movement of the tool could
otherwise result in an incorrect drilling depth
setting.
Inserting tools with SDS-plus shank
WARNING!
Remove the battery before carrying out any
work on the power tool.
CAUTION!
Used cutting accessories may become hot.
Wear protective gloves!
NOTE!
Tools used must have an SDS-plus shank.
If tools do not have an SDS-plus shank
(e.g. wood drill bit), a three-jaw chuck must
be used (see “Fitting the three-jaw chuck”).
Check the dust cap.
– Clean the cap if dirty.
– Have a defective dust cap replaced.
Clean tools and lightly grease the shank.
Insert the cutting accessory (1.) and
turn (2.) until it locks.
Check lock by pulling on the cutting
accessory.
430.013_CHE 18.0-EC.book Seite 17 Mittwoch, 30. September 2015 1:12 13
