Flex ADM 30, Manual, Page: 14 / 36

FLEX
ADM30
15
Checking precision
It is recommended to check the device regularly
to ensure that it is always precise.
If the precision deviates from the permitted
tolerance range, the device must be taken to a
customer service workshop authorised by the
manufacturer.
Have the device adjusted by authorised
technicians only.
The steps required to check the precision are
explained at the end of these instructions on the
illustrated pages.
See from page 162.
Maintenance and care
Observe the following instructions:
– Handle the measuring instrument with care
and protect it from impacts, vibrations and
extreme temperatures.
– Do not touch the receiver lens with your
fingers.
– Clean the lens with a soft, dry cloth only.
– Never submerse the measuring instrument in
water or other liquids.
– Keep the measuring instrument in a dry place.
– Have the measuring instrument repaired by
qualified technicians and with original spare
parts only.
This ensures that the safety of the measuring
instrument is maintained.
Disposal information
EU countries only:
Do not dispose of electric power
tools in the household waste!
In accordance with the European Directive
2012/19/EC on Waste Electrical and Electronic
Equipment and transposition into national law,
used electric power tools must be collected
separately and recycled in an environmentally
friendly manner.
Raw material recovery instead of waste
disposal.
The device, accessories and packaging should
be recycled in an environmentally-friendly
manner. Plastic parts are identified for recycling
according to material type.
429.279_ADM30.book Seite 15 Freitag, 4. März 2016 8:03 08