7. Disengage (2) plastic Latch Rod Retainer Clips using
your fingers. (Figure 2)
Figure 2
8. Remove Tailgate Handle using a Socket. (Figure 3)
Figure 3
9. Remove lock cylinder from original Tailgate Handle.
Remove Tailgate Lock Cylinder Retaining Clip and
then Tailgate Lock Cylinder and reinstall into
supplied Tailgate Handle Camera. (Figure 4)
Figure 4
10. Route Tailgate Handle Camera connector down
through Tailgate Handle opening then out through
the hole at bottom of Tailgate.
11. Pull Tailgate Handle Camera connector through the
pass-through hole in the rear of the pickup box.
12. Reinstall Tailgate Handle.
13. Reattach (2) plastic Latch Rod Retainer Clips using
your fingers.
14. Reattach Tailgate Access Panel.
15. (If equipped), reinstall plastic Tailgate Protector.
16. Close Tailgate.
Chassis Harness Pass Through
17. Using a Plastic Trim Removal Tool, remove Left
Instrument Panel Outer Trim Cover. (Figure 5)
Figure 5
18. Remove driver side door sill cover/kick panel cover.
(Figure 6)
Figure 6
19. Pull back driver side floor carpet.
20. Look for existing grommet or hole to run chassis
harness through. If no existing hole is available make
sure that there is nothing on the back side of pass
through opening (wiring, parking brake cable, etc),
mark center with a Center Punch and use a 1/2” Drill
Bit to make a pilot hole. (Figure 7)
