Brine Tank Float assembly:
6
The float assembly is a safety float; it only comes into play if there are failures in the
control valve to keep the brine tank from overflowing with water it does not dictate the
water level in your brine tank.
Measure from the top of the air check shown as # 6 in photo 10" to bottom of float shown
at # 3 in photo, you may have to gently push the float rod thru the rubber gametes to
achieve this. Cut any existing rod off.
Installing Float assembly in Brine well
.
4 3
2
1
Slide the float assembly into the brine well shown as # 1 in photo and stick stud into side
hole on brine well show as # 2 in photo and secure with the nut we have supplied you
Take the clear tubing that we have supplied and slide it thru the whole in the brine tank
and brine well shown as # 3 in photo. Slip the plastic nut from the float assembly over the
tube and insert the sleeve into the tube. Now insert tube into top fitting on float shown as
Page 4 of 7
Copyright © 2006 Quality Water Treatment, All right reserved. www.qualitywatertreatment.com
