The ceramic pebble fuel-bed remains hot for a considerable period after use
and sufficient time should be allowed for the fire to cool before cleaning etc.
The fire must only be operated with the Linear trim supplied with the fire
OPERATING THE FIRE
The controls are located behind the ashpan cover below the Linear trim.
The controls, comprise a control valve to adjust the gas flow and a push button
piezo igniter. To light the fire proceed as follows:-
1)
Depress the control knob and turn anti-clockwise to the position
marked pilot. Hold in the control knob for a few seconds to allow the gas to
reach the pilot.
2)
Continue to hold-in the control knob and press the igniter button. If the pilot
does not light, continue to press the igniter button until ignition
occurs. The pilot flame’s reflection can be seen by looking at the left hand
side front of the stainless steel side trim. When the pilot has lit, continue to
hold the control knob in for 5-10 seconds to allow the thermocouple to heat
up, if the pilot goes out when the control knob is released, repeat the lighting
sequence.
In the unlikely event of a failure of the igniter, the fire can be lit as follows :-
Depress the control knob and turn anti-clockwise to the position
marked pilot. Hold in the control knob for a few seconds to allow the gas to reach
the pilot. Insert the tip of a lit taper in behind the front ceramic pebble formation
on the left hand side. This will light the pilot flame.
When the pilot has lit, continue to hold the control knob in for 5-10 seconds to
allow the thermocouple to heat up, if the pilot goes out when the control knob is
released, repeat the lighting sequence.
3)
After lighting, turn the control knob in the anti-clockwise direction to the high
position and the main burner will light. It is recommended that for most
efficient performance the fire is allowed to warm up for a few minutes with
the gas control on maximum.
4)
The gas control can be turned clockwise from the maximum position to give
the desired heat output.
WARNING
If the fire goes out for any reason or is turned off and it is
necessary to relight the fire it is important to allow the fire to cool
for 3 minutes before attempting to re-light it.
4
