4.4.2
Isolate the gas supply, remove the glass frame as shown on page 17,
then remove the 2 off fixing screws which hold the pilot shield in place.
4.4.3
Loosen the pilot pipe, disconnect the ignition lead from the electrode,
and remove the thermocouple from the pilot body.
4.4.4
Remove the two fixing screws which secure the pilot assembly to the
pilot panel.
4.4.5
Remove the pilot assembly.
4.4.6
Re-assemble with an new pilot assembly, and gasket, ensuring than an
even seal around the pilot assembly is obtained. Carry out a gas
soundness test after re-assembly.
PARTS SHORTLIST
Replacement of parts must be carried out by a competent person such as a
CORGI registered gas installer. The part numbers of the replaceable parts are as
follows, these are available from your local Flavel Stockist, whose details may be
found on the BFM Europe website, address as shown on the back page of this
book.
Gas Valve
B-104440
Gas Valve (LPG)
B-104450
Piezo Igniter
B-1320
Ignition Wire
B-14340
Fuelbed
70-47800
Due to our policy of continual improvement and development the exact
accuracy of illustrations and descriptions contained in this book cannot be
guaranteed
Part No. B-103910
Issue 3
BFM Europe Ltd.
Trentham Lakes
Stoke-on-Trent
Staffordshire
ST4 4TJ
www.bfm-europe.com
Telephone - General Enquiries :
(01782) 339000
Telephone - Service :
(0844) 7700169
