Flash F7100515, User Manual

Page: 2 / 20


Please keep this User Manual for future
consultation. If you sell the fixture to
another user, be sure that they also receive
this instruction booklet.

Unpack and check carefully there is no
transportation damage before using the
fixture.

Before operating, ensure that the voltage
and frequency of power supply match the
power requirements of the fixture.

It’s important to ground the yellow/green
conductor to earth in order to avoid electric
shock.

Disconnect main power before servicing
and maintenance.

Use safety chain when fixes this fixture.
Don’t handle the fixture by taking its head
only, but always by taking its base.

Maximum ambient temperature is: 400C
WARNING!
The
LMH 150W
has a powerful pan motor. The torque reaction when the head
is panned suddenly can cause the base to move if the fixture is standing unsecured on a
surface. Do not apply power to the
LMH 150W
unless the baase is securely fastened to a
surface or to rigging hardware.
WARNING!
Use 2 clamps to rig the fixture. Do not hang the fixture from only one clamp.
Lock each clamp with both 1/4-turn fasteners. Fasteners are locked only when turned a full
900 clockwise.
WARNING!
When clamping the fixture to a truss or other structure at any other angle than
with the yoke hanging vertically downwards, use two clamps of half-coupler type. Do not
use any type of clamp that does not completely encircle the structure when fastened.
WARNING!
Position or shade the head so that the front lens will not be exposed to sunlight
or any other strong light source from any angle - even for a few seconds. See Figure 2. The
LMH 150W Spot
lens can focused the sun's rays, creating a potential fire hazard and causing
damage.
IMPORTANT!
Do not point strong light output from other fixtures at the
LMH 150
, as
intense illumination can damaged the display.
Don’t operate it where the temperature is
higher than this.

In the event of serious operating problem,
stop using the fixture immediately. Never
try to repair the fixture by yourself. Repairs
carried out by unskilled people can lead to
damage or malfunction. Please contact the
nearest authorized technical assistance
center. Always use the same type spare
parts.

Do not connect the device to any dimmer
pack.

Do not touch any wire during operation
and there might be a hazard of electric
shock.

To prevent or reduce the risk of electrical
shock or fire, do not expose the fixture to
rain or moisture.

The housing must be replaced if they are
visibly damaged.

Do not look directly at the LED light spot
while the fixture is on.
2. SAFETY INFORMATION
1. INTRODUCTION
THANK YOU FOR PURCHASING
LED MOVING HEAD 150W 2-31° ROTO PRISM
. FOR
SAFETY REASONS AND TO ENSURE THE TROUBLE-FREE OPERATION, CAREFULLY
READ THE INSTRUCTIONS.
W A R N I N G !
User Manual
•
Instrukcja Obsługi
Figure 2.
Lenses can focused sunlight and strong light, presenting a risk of fire and damage to the fixture.
Shield or shade the head if necessary.