User Manual
•
Instrukcja Obsługi
Please keep this User Manual for future
consultation. If you sell the fixture to
another user, be sure that they also receive
this instruction booklet.
Unpack and check carefully there is no
transportation damage before using the
fixture.
Before operating, ensure that the voltage
and frequency of power supply match the
power requirements of the fixture.
It’s important to ground the yellow/green
conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing
and maintenance.
Use safety chain when fixes this fixture.
Don’t handle the fixture by taking its head
only, but always by taking its base.
Maximum ambient temperature is: 400C
IMPORTANT!
Do not point strong light output from other fixtures
at the
BIG LOGO PROJECTOR
, as intense
illumination can damaged the display.
Don’t operate it where the temperature is
higher than this.
In the event of serious operating problem,
stop using the fixture immediately. Never
try to repair the fixture by yourself. Repairs
carried out by unskilled people can lead to
damage or malfunction. Please contact the
nearest authorized technical assistance
center. Always use the same type spare
parts.
Do not connect the device to any dimmer
pack.
Do not touch any wire during operation
and there might be a hazard of electric
shock.
To prevent or reduce the risk of electrical
shock or fire, do not expose the fixture to
rain or moisture.
The housing must be replaced if they are
visibly damaged.
Do not look directly at the LED light spot
while the fixture is on.
2. SAFETY INFORMATION
1. INTRODUCTION
THANK YOU FOR PURCHASING
BIG LOGO PROJECTOR IP65 300W
. FOR SAFETY
REASONS AND TO ENSURE THE TROUBLE-FREE OPERATION, CAREFULLY READ
THE INSTRUCTIONS.
W A R N I N G !
Figure 2.
Lenses can focused sunlight and strong light, presenting a risk of fire and damage to the fixture.
Shield or shade the head if necessary.
