FLARING FM 155E, Operation Manual

Page: 25 / 31

- 25 -
To avoid electric shock, please observe the rules
：

Do not touch live parts.
 Let relevant technicians connect the welder and base metal grounding correctly.
 It must switch off the power when installation, maintenance, and waiting 5 minutes before
operation. Capacitors can be charged, even if the power has been cut off, but also to ensure
that the capacitor is not charged voltage, and then operate.

Do not use cables that have insufficient cross-sectional area, damaged insulation sheath, or
exposed conductors
 In the cable connection, please ensure the insulation.

Do not use the welder when the case opened or removed.
 Do not use insulated gloves which is damaged or damped.

Please use safety net when working at height.
 Regular maintenance and repair, and please repair the damaged parts before using.
 When not in use, turn off all input power.

When using AC arc welder in narrow places or higher places, please observe the relevant
national and local standards and regulations.
To prevent fire and explosion, please observe the following rules ：

Do not place flammable materials near the welding place.
 Do not welding near flammable gas.

Do not place the hot finished base material close to flammable material.
 When welding in the patio, on the ground and the wall, please remove the combustible
materials on the back.

The cable connected with the base metal as close as possible to the welding spot.
 Do not welding gas-filled trachea, seal groove, etc.

Place a fire extinguisher near the welding work site to prevent the fire from happening.
To avoid breathing these fumes and gases hazardous to health, please use
the required protective equipment.
 To prevent accidents such as gas poisoning and suffocation, please use the prescribed
exhaust facilities and use respiratory protection equipment.
 To prevent welding fumes and other dust damage and poisoning, please use the prescribed
local exhaust equipment and respiratory protective equipment.
 When working in cabinets, boilers, cabins, etc., CO2, which is heavier than air, stays at the
bottom. To prevent lack of oxygen, please fully ventilate and use an air respirator.
 When working in a confined area, please accept the inspection of the supervisory staff, and