Flamerite Fires Glazer 1000, Installation, Precautions & Servicing

Page: 16 / 19

16 | P a g e
We recommend two persons to fit the Glazer 1500 & 1800 glass
Push the side glass back towards the rear of the case A
You will notice there is a long gap on the underside of the opening 10mm in width that runs along and in front
of the heater grills. At an angle of approximately 45 degrees push the glass up into this void making sure the
bottom of the glass clears the lower edge of the opening. Tilt the glass back into the fire and carefully lower
into the large channel that runs across the opening avoiding the dampers B & C
Slide the handle D along the top right-hand side of the glass.
The upper glass rail is magnetic and will fix easily into place along the top of the opening
E
. Adjust the
position of the handle accordingly into the gap on the rail.
With the front glass tilted rearwards pull the side glass side forwards F . To open and close the front glass
panel, place your index finger on the handle as shown in the picture G . You may finely position the front and
side glass panels to give the best possible fit and finish. Make sure the front glass glides back with ease and
depresses the micro switch arm on the underside of the heat housing.
Glass Fitting & Removal