5
3. Handling
For beginning the record sequence please push the REC button (blinking yellow LED). You can
record the movements of the ruler until you push again the button REC or until up to the maxi-
mal record time of 102 seconds. Now the record sequence stops and jumps automatically in the
Play loop mode (yellow LED on).
The voltages of pot one and CV-1 input will be added and also recorded. The output voltage is
limited to +10V.
If ruler one is on position Zero you can record the control voltages of input CV-1, e.g. LFO’s in
the range of 0..+10V. The sample rate is 50Hz (50 values per seconds). Pot one serves like an
offset ruler.
From mode KNOB or PLAY you can start a record sequence anytime.
After power on the module stands in KNOB mode. All LEDs are off. With the pot you can adjust
an output voltage between 0 and +10V. The voltages of pot one and CV-1 input will be added.
Pot one serves like an offset ruler.
You activate the manual mode by pushing the button KNOB.
After a record sequence the play back of the track starts automatically in loop (yellow LED on).
If you are in mode KNOB (LED off) then you can start the play back with pushing the button
PLAY. Please note the both versions of pushing (short or long):
ONE SHOT
- Track plays once only: Push the button shortly (< 0,5sec)
PLAY LOOP
- Track plays in loop: Push the button longer (> 0,5 sec)
ATTENTION:
Reset can start the track (or tracks) while Play mode is activated (LED on).
3.2 Record
3.1 Manual mode (Knob)
3.3 Play back