background image

3

  

WARNING

 

For residential use only! NOT for commercial use! 

Any commercial or public use of this 

  heater 

voids all warranties , 

and could cause 

injury

.

 This product is 

not intended

 to be a  

primary heat source

.  It is for

 supplemental heat only

.

 I

NDOOR use only! NEVER

  use this heater 

outdoors! 

 Doing so may result in  

electric shock!

 

NEVER modify this heater. 

Doing so could result in personal

 injury

 or property

 damage

.    

  Modification of this fireplace  

completely voids all warranties

.

 

ALWAYS

 turn this heater off before unplugging it from the outlet.

 

ALWAYS disconnect

 this unit from the  

power 

supply  

before

 performing any assembly   

  or cleaning, or before relocating the product.

 

NEVER

 leave this heater unattended. 

ALWAYS

 unplug this heater when not in use.

 

ALWAYS

 store this heater in a dry location.  

NEVER

 use the product if it has become wet.

 

 

 

 

 

 

 

 

 

 

NEVER

 plug this heater into an outlet that is  

old

,

 cracked

, or has any 

loose wires

 

or

  

 

connections

. Plugging this heater into a faulty outlet could result in  

electric arcing

 within   

  the outlet that could cause the  

outlet

 to  

overheat or catch fire

.

 

ALWAYS

  check your heater cord and plug connections with  

each use!

i)  

Make sure

 the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs 

 

    can cause the outlet to overheat.

 

ii) 

Heaters draw more current

 than small appliances.  

Overheating

 may occur even if it has 

 

   not occurred with the use of other appliances.

 

iii)  During use 

check frequently

 to see if the  

plug outlet

 or  

faceplate is HOT!

 

iv) If the outlet or faceplate is 

HOT,

 

discontinue use immediately

 and have a qualified  

 

electrician inspect and/or replace the faulty outlets.

 The power cord supplied with the heater has   

  three prongs: two flat blades (live and neutral)  

  and one round pin (ground). If a 3-slot 

 

  is not available, an adapter 

MUST

 be used.  

  The adapter 

MUST

 be properly grounded   

  to the outlet box (see figure at right).  

 

[NOTE: Adapter NOT INCLUDED.]

ONLY

 use this heater on a 

120V AC 15-Amp grounded circuit

.

 NEVER overload the circuit

. If this 

heater trips the circuit breaker, unplug all other appliances on the same circuit before the next use.  

Avoid plugging other appliances into the same circuit as this heater

.

3

Risk of electric shock!

 

DO NOT REMOVE THE COVER!

 NO user-serviceable parts inside!

outlet

Ensure a wall outlet is close by so an extension cord is not needed.

Summary of Contents for COLORADO EFI-TJ23B2













Reviews: