Flagro FLE-150RC, Operating Instructions Manual

Page: 3 / 25

Introduction
You have just received an FLE-150RC 150kW Electric Construction Heater manufactured by Flagro.
Use: The FLE-150RC Electric Construction Heater is designed for temporary heat only.
The heater is to be installed indoors
The FLE-150RC is designed to heat large spaces, buildings
and machines without worrying about on site fuel.
Quality : The FLE-150RC is built with the highest quality of components, giving our
customers the confidence they deserve in a Flagro product.
Convenience: The FLE-150RC gives our customers the flexibilty of a 60kW/90kW/150kW heat setting.
The heater is equipped with a; fan speed inverter control that provides optimum temperature rise
by adjusting blower output at each heat setting. Colour coded Cam Lock power connections
for easy installation. Remote thermostat option available.
Inlet Duct Adapter
The FLE-150RC includes a permanant inlet duct adapter.
Safety
Always verify that you have proper voltage supply. (575V) It is important to check
the wiring connections inside the heater before plugging in the Cam Locks.
Use a meter to measure volt supply to each cam lock.
Work on the internal systems should only be attempted by a certified electrician and
only when power has been disconnected and can not be reconnected to the heater.
Grounding
The heater is supplier with a cam lock system with a grounding connection and is indicated with a "G"
on the cam lock panel. The heater is also supplied with a grounding nuts found on all panels.
It is very important to double check that all grounding connections are properly secure.
Clearance from Combustibles
The discharge temperature of these units may reach very high temperatures. Maintain minimum
distance from combustible materials as follows:
Top: 6 Inches
Bottom: 6 Inches
Sides: 6 Inches
Discharge: 15 FT