►IMPORTANT:
When using a saline rinse, always use distilled water. Tap water may
contain harmful bacteria that can get into your nasal passages. If you can not find
distilled water, boil water for 5 minutes and allow it to cool until it is lukewarm. Dispose
of boiled water within 24 hours.
Contact: [email protected]
www.RhinoClearSprint.com
Use
1.
Pour contents of one vial of saline solution into the
chamber of the flask that contains the white atomizer tip.
The other side with the icon of a person on the chamber
is for collecting discharge.
2.
Place the clear plastic lid back on the flask. Then
attach the blue rubber nasal adapter on top of the lid.
3.
Place the blue tip of the nasal adaptor inside one
nostril. Make sure the discharge side (with the icon of
the person) is facing you. Start the atomizer by holding
down the green button and breathing in gently (as if you
are smelling a flower) for 10 seconds. Release the
button while breathing out.
4.
Repeat for the opposite nostril. Switch back and forth
while atomizing, dividing the saline solution evenly
between both nostrils.
5.
After use, clean atomizer with warm water and soap.
DO NOT PUT ATOMIZER PARTS IN BOILING WATER.
Pour in side
that has
atomizer tip
Place lid
back on
flask
Atomize!
QuickStart Guide
